|
|
|
I thank Jim Gagnon for his post and thread about using cohesive corrugated cardboard wrap to mail chips to keep the postage cost down. The key thing seems to be to both protect the chip(s) and keep the packed envelope at less than 1/4" thick. (There are now three categories of first class mail: (a) "letters" are the cheapest to send, but must be less than 1/4" thick; (b)"large envelopes" (flats) are the second cheapest, but must be less than 3/4" thick; and (c) "parcels" are the most expensive and can be over 3/4." It seems that the good old bubble wrap envelopes will be classified by the post office as "parcels" regardless of thickness.) Reading the thread prompted me to think about the problem, and I came up with this easy solution.
As the picture below shows (it is probably unnecessary to have the picture, but what the heck!):
1. place the chip or chips on a piece of paper.
2. keeping the chips touching but not overlapping, fold the paper over the chips, encasing the chips.
3. tape the resulting little bundle.
4. tape the bundle to the letter, fold in thirds and place in the envelope. (I like to tape the two sides of the envelope too).
This won't go over a 1/4." You just pay the letter rate plus 17 cents extra for the non-machinable fee. The chips are very secure. You save paying the 25 to 30 cents for the cohesive corrugated cardboard wrap. The chips have a little less cushioning but (1) that helps in keeping the thickness under 1/4"; and (2) since you are sending only non-valuable sturdy casino chips this way, the rare cases of breakage (which could happen even with cohesive corrugated cardboard wrap) are easily outweighed by the savings in postage over the long run. One disadvantage to this method is that it is a little more time consuming than the cohesive corrugated cardboard wrap way.
In the thread, I also liked the ideas about using cereal box cardboard and Starbucks coffee cup holders.
Robert
|
|